FORM NO. 56043042 / Whirlamatic
™
2700 / BHS 7014 - 11
BURNISHING SYSTEM
H
FRONT
K
G
J
I
L
D
E
F
B
A
C
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
PAD LIFT ACTUATOR REMOVAL AND INSTALLATION
1
Place the pad deck assembly in the down position and disconnect the battery pack.
2
Disconnect the pad lift actuator motor electrical cord assembly.
3
See Figure 6. Remove the (2) (A) Screws and the Mount Weldment (B) from the Main Lift Linkage (C).
4
Remove the Retainer Ring (D) and slide the Pin (E) out to remove the Lift Actuator Motor (F) from the machine.
5
Remove the (2) (G) Screws and remove the Nut Retainers (H & I) from the Spring Housing (J).
6
Separate the Spring Housing (J) and the Compression Spring (K) from the Plastic Drive Nut (L).
Installation of a new pad lift actuator motor:
7
Follow steps 2-17 of the
Actuator Lift Nut Adjustment
section.
revised 2/02
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
PAD LIFT ACTUATOR DRIVE NUT REPLACEMENT
1
Remove the Pad Lift Actuator from the machine. Follow steps 1-6 of the
Pad Lift Actuator Removal and Installation
section.
2
Spin the Plastic Drive Nut (A) off of the motor shaft.
3
See Figure 1. Install a new drive nut on the motor shaft and turn to the 2-1/4 to 2-3/8 inch (5.71 to 6.04 cm) DOWN position discussed
in step 15 of the
Actuator Lift Nut Adjustment
section. NOTE: Make sure the pin holes are orientated towards the end of the motor
shaft as shown.
4
Follow steps 1-6 of the
Pad Lift Actuator Removal and Installation
section in reverse order to re-install the Lift Actuator in the
machine.
FIGURE 6
