FORM NO. 56043042 / Whirlamatic
™
2700 / BHS 7014 - 25
STEERING / BRAKING SYSTEM
FRONT
B
A
C
D
E
F
Brake Pedal Lever Position:
1
See Figure 3. Remove the Brake Return Spring (A) and loosen the Lock Nut (B).
2
Adjust the Turnbuckle (C) in or out until the Brake Pedal Lever (D) is 1/2 inch (12.7 mm) down from the top of slot in the chassis.
NOTE: Brake Arm (E) must not bottom out against slot in the caliper.
3
Tighten the Lock Nut (B) and re-install the Brake Return Spring (A).
4
Test the brake for proper operation, the brake pedal should have about 1/2 inch (12.7 mm) of free play before the brake engages.
FIGURE 4
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
BRAKE CALIPER REPLACEMENT
1
Follow steps 1-3 in the
Wheel Drive Chain
Adjustment
section to gain access to the
brake assembly.
2
Remove brake pedal return spring.
3
See Figure 4. Remove brake link Cotter Pin
(A) and remove Brake Link (B) from the brake
lever. NOTE: Brake Link (B) MUST connect
to the bottom hole as shown.
4
Remove the two (C) Nuts and (D) Bolts and lift
Bracket (E) off with the Brake Caliper (F).
5
Slide the Brake Caliper (F) off of Bracket (E)
and install a new Brake Caliper.
6
Re-assemble in reverse order and adjust
according to
Brake Adjustment
section.
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
BRAKE ADJUSTMENT (CONTINUED)
FRONT
B
A
C
D
1/2"
(12.7 mm)
Slot in chassis
E
FIGURE 3
revised 2/02
