FORM NO. 56043042 / Whirlamatic
™
2700 / BHS 7014 - 29
ELECTRICAL SYSTEM
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
NEW BATTERY PACK SET-UP
1
See Figure 1. Pull the Battery Tray (A) and the Battery Box (B) out of the machine chassis and center the assembly on a pallet
jack with the side rails of the Battery Box (B) parallel to the pallet jack forks. IMPORTANT: The Battery Box (B) must be on the
pallet jack before placing the batteries in the Battery Tray, or you will not be able to get a pallet jack under the Battery Box. NOTE:
A 27” (68 cm) or narrower pallet jack is required, a pallet jack any wider will not work!
2
Place the batteries into the Battery Tray and connect the Battery Cables (C) as shown. Connect the Connector Assembly (D) as
shown (black cable to negative terminal / red cable to positive terminal).
3
Install the Battery Post Boots (E). Secure tightly to battery cables with supplied tie straps.
4
Raise the jack until the battery box will clear the side rails in the chassis and then roll the battery box into the battery compartment
until it contacts the other side of the chassis and then lower it onto the side rails in the chassis.
5
Connect the Battery Pack Connection. Open the Battery / Controller Compartment Cover to provide proper ventilation.
6
Push the connector from the charger into the Machine Battery Charger Port. Follow the instructions on the battery charger.
7
Check the fluid level in all battery cells after charging the batteries. Add distilled water, if necessary, to bring the fluid level up to
the bottom of the filler tubes.
Pallet Jack Forks
A
B
C
D
E
Chassis Side Rails
FRONT
Battery Box
Side Rails
FIGURE 1
revised 2/02
