14 - FORM NO. 56043042 / Whirlamatic
™
2700 / BHS 7014
BURNISHING SYSTEM
A
FRONT
B
C
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
PAD DRIVE MOTOR REPLACEMENT
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
PULLEY REMOVAL
C
A
FRONT
B
B
D
D
E
1
Follow steps 1-6 of the
Pad Drive
Belt Replacement
section.
2
See Figure 10. To remove the Motor Pulley (A), remove
the two (B) set screws from Motor Pulley (A).
3
To remove the Pad Drive Deck Pulley (C) remove the two
(D) set screws and gently pry pulley off of the Pad Shaft
(E). Be careful not to damage the pad drive deck.
4
When re-installing the pulleys, make sure they are orien-
tated and flush with the ends of their perspective shafts
as shown.
1
Follow steps 1-11 of the
Pad Drive Deck
Removal
section and steps 1-6 of the Pad
Drive
Belt Replacement
section.
2
See Figure 9. Tip the pad drive deck assem-
bly back onto the motor to gain access to the
four (A) motor bolts.
3
Remove the four (A) motor bolts. Note the
orientation of the motor terminal studs be-
fore separating the motor and shroud.
4
Remove the Pad Deck Shroud (B) from the
Motor (C).
5
Re-assemble in reverse order and test for
proper operation.
FIGURE 9
FIGURE 10
revised 2/02