20
WWW.NILESAUDIO.COM
INSTAllING THe SySTem CoNTINued...
connect the amplifier module and nileS Swt (powered modelS)
1. Prepare the speaker wire by stripping 1/4” from each conductor (see
Figure 10
on
page 18). Twist the strands or tin the leads with solder to ensure there are no stray strands that could
short and possibly harm the amplifier.
2. Connect the speaker wires and the Amplifier Module power cable to the Amplifier Module using the
supplied two phoenix connectors and a small screw slotted screw driver making sure to connect in the
proper order and polarity.
3. Connect all the other wires and cables routed to the Amplifier Module and SW-T as depicted in the system
diagrams starting on page 24, that best matches your configuration. Important: Do not plug in the AC
power cord until all other system connections are complete.
NOTE:
After ensuring all the connections are made correctly, plug in the AC power cord and test the operation of the system
before completing the installation in the next steps and snapping the modules into the rails.
inStall the in between coverS and JoinerS (all modelS)
The empty spaces that are created in the In-Wall Mounting System “in between” the installed
Speaker Modules and Amplifier Module are filled by the supplied In Between Covers and
Joiners. In Between Covers are pre-scored and designed to be broken into the sizes needed
to fill these variably sized spaces. In Between Joiners are designed to cover the seams of
adjacent In between Covers. A 3/8” overhang is included on both sides of the Amplifier and
Speaker Modules to make sizing the In Between Covers easier.
1. Identify and measure all of the spaces left in between the Speaker and
Amplifier Modules.
2. Run a razor knife along a pre-scored marking on the back of the In
Between Covers and break those into the sizes needed
(see
Figure 12
).
NOTE:
You must include a space of 3/8” to 1/2” between any two In Between Covers that will be installed adjacent to each
other. This will allow room for an In Between Joiner to be installed and to hide the seam.
3. Install the sized In Between Covers by snapping them into their respective empty spaces
(see page 21
Figure 13
).
4. Install an In Between Joiner by snapping it into the 3/8” to 1/2” space left between any two In Between
Covers (see page 21
Figure 13
)
Figure 12:
Sizing the
In Between Covers
