16
WWW.NILESAUDIO.COM
INSTAllING THe SySTem CoNTINued...
inStall the in-wall power Supply box (powered modelS only)
1. Choose a location to install the In-Wall Mount Power Supply that is
either behind or below the TV and adjacent to an existing AC outlet
(page 14
Figure 6
), Perform the steps listed on page 15 at the proposed
power supply location. Use the supplied In-Wall Power Supply Box
cutout template to mark the wall for cutting if there are no
obstructions found.
2. Route the 24V AC power wire on the rear of the power supply into this wall cutout and then out of the wall
at the speaker cutout location.
3. Fold in each of the four mounting clamps and insert the Power Supply Box into the wall cutout. Tighten each
of the four wall clamp screws inside the front edge of the power supply box to secure it in the wall.
DO NOT OVERTIGHTEN.
4. Screw the supplied finish faceplate on to the In-Wall Power Supply Box.
Important:
Do not plug in the AC power cord until all other system connections are complete.
aSSemble and inStall the in-wall mounting SyStem (all modelS)
1. Determine the number of Screw Down Slide Brackets needed for In-Wall Mounting System by counting the
number of wall studs that are exposed within the drywall cutout.
2. Slide the Screw Down Slide Brackets onto the Top and Bottom Rails as shown in
Figure 7
and position them
to align with the exposed wall studs within the drywall cutout.
3. Insert a Clamp Down End Bracket, as shown in
Figure 7
, on the ends of the Mounting Rails that fall more
than 3” from a Screw Down Slide Bracket. See
page 13
Figure 5
when the left or the right end of the
Mounting Rail falls too close to the side of a wall stud to provide the Clamp Down End Bracket with enough
drywall for clamping.
4. Align with and place the assembled In-Wall Mounting
System into the wall cutout and loosely screw the
Screw Down Slide Brackets to the wall studs with the
screws provided. Final tightening of these screws will
occur later in the installation procedure.
Figure 7:
In-Wall Mounting System
Screw Down Slide Bracket
Clamp Down End Bracket
power Supply cutout
Dimensions (HxW):
3-11/16” x 8-3/8”
9.4cm x 21.3cm