Nidec FGV-HXY, Руководство по эксплуатации

Страница: 3 / 34

Caution
Safety Precaution
Caution
Caution before use.
•Location which will be gotten water
•Locations which receive direct sunlight
•Dew condensation place
Do not use AC plug covered with dust.
Do not use and keep FGV under the
following circumstances.
Please use the FGV in operating
temperature in range 32 - 104°F
(0 - 40°C).
A potential fire hazard may exist
To clean the FGV do not use a volatile chemical
such as benzene, thinner or alcohol. Only use a
dry soft cloth or a cloth soaked in a mild detergent
that is mixed with water.
If you use FGV beyond above temperature,
FGV might operate unusual.
1. Do not press the button with
a sharp-pointed object.
2. Do not load in an axial direction
PEAK ZERO
MEM
UNIT
PEAK ZERO
MEM
UNIT
PEAK ZERO
MEM
UNIT
The FGV can measure pulling and compression loads, but not loads
in a rotational direction. The FGV is equipped with a limit stopper.
However, this is unable to prevent damage from a heavy impact load
or excessive axial forces.
Bending direction
Twisting direction
Accuracy performance degrades overtime. It
is recommended the force gauge be checked
for performance regularly. The frequency of the
checks is dependent on the frequency of use and
loading.
3. Do not drop the force gauge.
Do not allow the force
gauge to fall. The sensor
can become damaged
and will no longer be
able to perform properly.
PEAK
ZERO
MEM
UNIT
4. Do not use the force gauge in locations where it may get wet.
This force gauge is not water
proof. Please do not operate
the force gauge in locations
where it may get wet.
PEAK
ZERO
MEM
UNIT
5. Measuring very small loads
Factory default, the tracking setting
is set to ON. When measuring small
loads, turn the tracking setting to
OFF. Refer to Tracking Section for
further details.
PEAK ZERO
MEM
UNIT
Please operate the force gauge
within operating humidity range;
35-85% RH.
If you use the force gauge beyond the above
range, it might produce improper operation.
•Dusty, salinity and iron content environments
•Location which will be gotten oil and chemical
•Corrosive and Flammable gas environment
Overload