-19-
Key operation
Display
Turn power off
PEAK
ZERO
MEM
UNIT
1. Hold down MEM key
2. Press POWER key
PEAK
ZERO
MEM
UNIT
Release POWER key only
ZERO
Delete the data when last memory data is displayed.
UNIT
Display the statistics memory data.
PEAK
Output the memory data with RS-232C, and then move to standard measuring mode.
Finish display of the memory data. (Turn the power off)
6.7.Recalling memory data
6.7.1.Continuous memory mode
1. Turn the POWER off. Press MEM key and hold, then press and release POWER. Release MEM when you see "CNT" on the display.
The unit will alternate between showing the data block number, and the recorded measurement value of that block.
2. Press MEM to review the previous data block recorded.
3. Press UNIT to cycle through the available recorded statistics. In Continuous mode the available statistics are as follows: positive
maximum value, negative maximum value, positive minimum value, negative minimum value, positive peak value, negative peak value,
average value, standard deviation. This is covered in greather detail in the next section.
4. Press PEAK key to output the recorded memory via RS-232C. Refer to section 7 regarding RS232C communication.
Last memory number
Last memory number-1
Memory number 1
MEM
MEM
Display one after the other
Display one after the other
Display one
after the other
Please release the
MEM key after the
value iappears in the
display more than 1
second.
6.7.1.1.Measuring memory data
1.
2.
MEM
Содержание FGV-HXY
Страница 34: ...33...