CBOX936
INSTALLATION AND PROGRAMMING MANUAL
26
14
BLUEBUS PHOTO EYE ALIGNMENT
NOTES:
Photo eye testing is described in INSTRUCTION 15.
Adjustment instructions apply only to EPMOB/A and EPLOB/A models. EPMB/A model is not adjustable,
and must be adjusted using other mechanical means left up to the installer.
B
A
1. Pull off front cover from photo eye assembly.
2.
Use medium Phillips screwdriver to loosen screw (A).
3. Place screwdriver in hole (B) and lever the entire assembly in desired direction to change the angle of
the entire assembly by up to 15 degrees in all directions (30 degrees total).
4.
Observe LED behavior during adjustment and stop adjustment when LED flashes very slowly.
5.
Re-tighten screw (C). Do not replace covers until after photo eye testing is performed in INSTRUCTION
15.
C
If adjustment of photo eye alignment is necessary, refer to the following instructions:
www.ApolloGateOpeners.com | (800) 878-7829 | [email protected]
