CBOX936
INSTALLATION AND PROGRAMMING MANUAL
19
8.1 POWER OPTIONS AND WIRING
There are two possible configurations available to power the 936 control board:
•
12 VDC battery charged by solar panel
•
12 VDC battery charged by AC-DC charger applied to battery
IMPORTANT!
Power should not be applied to the control board until after the
photo eyes have been installed and wired to the control board.
Power is applied in INSTRUCTIONS 8.
1. Remove BATTERY connector from control board (IMAGE 8-1).
2. Retrieve black/red battery cable from kit, strip bare wires
back 3/8”-7/16” (10-11mm), twist, and install into the Battery
connector screw terminals (RED = +, BLACK = -).
3. Attach the battery cable lugs to the battery terminals; black to
negative (-) and red to positive (+) terminals.
4. Plug battery connector back in control board (IMAGE 8-1).
8
BATTERY POWER - INPUT CONNECTIONS
BATTERY POWER INPUT CONNECTOR
NOTE:
If Battery power is wired backwards the LED (upper right of connector) will light red. If wired
correctly, the LED will light green.
IMAGE 8-1:
BATTERY POWER INPUT CONNECTOR
DANGER!
DO NOT CONNECT AC POWER DIRECTLY TO MAIN
DC POWER CONNECTOR ON CONTROL BOARD!
THE BOARD ACCEPTS ONLY DC VOLTAGES!
www.ApolloGateOpeners.com | (800) 878-7829 | [email protected]
