CBOX936
INSTALLATION AND PROGRAMMING MANUAL
24
7. If a dual gate system, plug both actuator motor connectors into Control Board, ensuring that the second
actuator with longer cable is plugged into MOTOR 2 connector.
8.
Press the OK button. The board automatically begins the limit learning process and the gate(s) moves
automatically as follows:
a) A short opening sequence at half speed to determine the number of motors.
b) A full closing cycle at half-speed to determine close limits (CLOSE LED lights at limit).
c) A full opening cycle at half-speed to determine open limits. (OPEN LED lights at limit).
d) A full closing cycle at full-speed into the closed position. (CLOSE LED lights at limit).
9. The OPEN and CLOSE buttons can now be pressed once (without holding) to fully open and close the gate.
11: GATE LIMIT LEARNING PROCEDURE (CONT.)
Standby Mode puts the board into a low power consumption
mode after about 2 minutes of inactivity in the “unlearned” state
and after about 20 seconds after the board has “learned” the
current system. A press of any button wakes up the board from
Standby Mode. Select ON or OFF as follows:
1.
Press OPTIONbutton.
2.
Use UP/DOWN buttons to scroll to standby option “Sb”.
3.
Press OK.
4.
Use UP and DOWN buttons to select 1 (ON) or 0 (OFF).
5. Press OK.
6. Once Standby Mode is on, the control board will go to sleep after a time of inactivity when the
operator is not moving, is in the auto-close countdown, or is being held open by an external
auxiliary input.
SELECT CONTROL BOARD STANDBY MODE
12
NOTES:
24 volt output on right side
and 12 volt output at top of
board will turn off during
Standby Mode - do not
power entry or exit devices
from these outputs.
BlueBUS function is disabled
until board "wakes" up. Press
any button to wake.
IMPORTANT!
For solar applications turn Standby Mode ON.
www.ApolloGateOpeners.com | (800) 878-7829 | [email protected]
