CBOX936
INSTALLATION AND PROGRAMMING MANUAL
29
18
ASSIGNING NEW REMOTE CONTROL
Procure a functioning Nice 2-button or 4-button remote control with a battery installed (IMAGE 18-1) and
assign it to the Nice
OXI/A
receiver as follows:
1. Press and hold the program button on the side of the Nice
OXI/A
receiver module (IMAGE 18-1, Left)
until the green LED lights up on the side of the receiver, then release the button.
2. Within 10 seconds, press and hold any key on the Nice remote control until the LED in the Nice receiver
blinks green 3 times, indicating that the remote control is programmed to control the receiver.
3. After the LED on the Nice receiver blinks green 3 times, another 10 second interval is started to program
another Nice remote control if desired.
4. Repeat step 3 to program the additional Nice remote control (transmitter). Step 3 may be repeated as
many times as necessary to program all available Nice remote controls.
5.
Verify that the Nice remote control(s) can control the gate by pressing one or more buttons individually
on the remote control(s). If remotes do not function properly - refer to Section 9.19 to assign the correct
function to the radio channels using the OPTION button and Radio Channels option.
GREEN
LED
PROGRAM
BUTTON
IMAGE 18-1:
OXI/A RECEIVER (LEFT),
2-BUTTON REMOTE (MIDDLE) & 4-BUTTON REMOTE (RIGHT)
www.ApolloGateOpeners.com | (800) 878-7829 | [email protected]
