CBOX936
INSTALLATION AND PROGRAMMING MANUAL
13
SECTION 8: 936 CONTROL BOX INSTALLATION & SETUP
NOTES:
Mounting holes
and hardware for the
control box are NOT
included. Drill holes as
needed and use hardware
capable of supporting the
weight of the control box
with the battery included.
CONTROL
BOX
PIVOT ARM
LOCATION
GATE
6 FOOT
MINIMUM
IMAGE 1-1:
CONTROL BOX MOUNTING LOCATION
1
MOUNT CONTROL BOX
1. Mount control box on same side as actuator (for dual gate systems, same side as MASTER actuator
with shorter harness) and at least six feet away from the pivot arm (FIGURE 1-1).
2. Set battery inside of control box with terminals toward the front.
LOCATE
BATTERY HERE
IN CBOX936
CAUTION!
DO NOT MOUNT THE CONTROL BOX WHERE THE PERSON USING THE PUSH BUTTON ON
SIDE OF BOX CAN COME IN CONTACT WITH THE GATE!
NOTE:
IMAGE 1-1 shows a typical install. The control box may be installed on either side of the wall
depending on which direction the gate opens or where a person monitoring the gate will be located.
www.ApolloGateOpeners.com | (800) 878-7829 | [email protected]
