English –
17
25
26
When connecting 2 NiceHansa Robus in the Master-Slave mode, pay attention that:
• All devices must be connected to the NiceHansa Robus Master (as in fig. 26) including the radio receiver.
• When using buffer batteries, each motor must have its own battery.
• All programming performed on NiceHansa Robus Slave are ignored (those on NiceHansa Robus Master override the others) except for those men-
tioned in table 14.
LUCYB
S.C.A.
MOFB
MOSE
OPEN CLOSE
LUCYB
S.C.A.
STOP
PP
7.3.5) NiceHansa Robus in “Slave” mode
Properly programming and connecting, NiceHansa Robus can func-
tion in “Slave” mode; this type of function is used when 2 opposite
gates need to be automated with the synchronised movement of the
two leaves. In this mode NiceHansa Robus works as Master com-
manding the movement, while the second NiceHansa Robus acts as
Slave, following the commands transmitted by the Master (all Nice-
Hansa Robus are Masters when leaving the factory).
To configure NiceHansa Robus as a Slave the level one “Slave mode”
must be activated (see table 7).
The connection between NiceHansa Robus Master and NiceHansa
Robus Slave is made via BlueBus.
In this case the polarity of the connections between the
two NiceHansa Robus must be respected as illustrated in
fig. 26 (the other devices remain with no polarity).
Follow the operations below to install 2 NiceHansa Robus in the Mas-
ter and Slave mode:
• Install the 2 motors as indicated in fig. 25. It is not important which
motor is to function as Slave or Master; when choosing, one must
consider the convenience of the connections and the fact that the
Step-by-Step command of the Slave only allows the Slave leaf to be
opened fully.
!
• Connect the 2 motors as shown in fig. 26.
• Select the opening direction of the 2 motors as shown in fig. 25 (see
also paragraph “4.1 Choosing the direction”).
• Supply power to the 2 motors.
• Program the “Slave mode” on the NiceHansa Robus Slave (see table
7).
• Perform the device recognition on the NiceHansa Robus Slave (see
paragraph “4.3 Recognition of the devices”).
• Perform the device recognition on the NiceHansa Robus Master (see
paragraph “4.3 Recognition of the devices”).
• Perform the recognition of the leaf length on the NiceHansa Robus
Master (see paragraph “4.4 Recognition length of the leaf”).
Содержание Robus 250
Страница 1: ...NiceHansa Robus Instructions and warnings for installation and use 250 500...
Страница 24: ......
Страница 27: ......