Nibe PELLUX 100, Инструкция по установке и обслуживанию

Страница: 40 / 76

Service settings
Module configuration
This menu is used to make settings in CAN.
NOTE
Before settings are made in the control computer,
the dipswitch must be set to the correct position for
the new accessory, see Connecting modules on page
44.
In the menu, mark the modules that are used in this partic-
ular system.
Description Module
Three heat circuits numbered
2, 3 and 4. Module 0
External temperature sensor.
Three heat circuits numbered
5, 6 and 7. Module 1
Three heat circuits numbered
8, 9 and 10. Module 2
Three heat circuits numbered
11, 12 and 13. Module 3
Three heat circuits numbered
14, 15 and 16. Module 4
Accumulator tank Module 5
Solar heating
Hot water circuit 2.
Temperature sensor for return
water.
Outside sensor.
Main module for the boiler. Module 6
Extra boiler module Module 7
Module for lambda sensor. Lambda module
System configuration
This menu is used to make settings in the hydraulic sections
of the heating system.
The setting possibilities are restricted by the which modules
are marked in the CAN settings and are used in this partic-
ular system.
Description Module
Determines how many heat-
ing circuits are connected to
the system. Number of heating circuits
Determines how many hot
water circuits are connected
to the system. Number of hot water circuits
Determines how many buffer
tanks are connected to the
system. Number ac.tanks
Determines if the system has
an external temperature
sensor or not. (module 0) Outside temperature sensor
Description Module
Determines if the system has
a return temperature sensor
or not. (module 5) Return sensor
Determines if the system has
solar panels or not. Solar heating
Reset factory settings
This function is used to reset the control computer settings
to the factory settings.
PELLUX 100 38
For the Installer
Service