Nibe PELLUX 100, Инструкция по установке и обслуживанию

Страница: 17 / 76

Electrical connections
Connection
Disconnect the heat pump before insulation testing the
building.
PELLUX 100 must be installed via an isolator switch with
a minimum breaking gap of 3 mm.
The boiler requires 230 V NAC 50 Hz
Connect the voltage/supply according to electrical wiring
diagram, see page 59.
The boiler must be connected to a dedicated power cable
protected by a 10 A fuse and an earth-fault breaker.
NOTE
Electrical installation and service must be carried out
under the supervision of a qualified electrician. Elec-
trical installation and wiring must be carried out in
accordance with the stipulations in force.
NOTE
No other consumers may be connected to the boiler's
power supply.
Internal fuse protection
The automatic heating control system, circulation pump,
burner and their wiring are internally fuse protected by a
miniature circuit breaker.
Connecting the control computer
NOTE
Power supply to the heating system must be broken
when the control computer is connected!
The control computer must be connected to all units in
the heating system to control them. The control computer
also requires that certain settings are made before the
boiler can be started. For instructions see
Setting the con-
trol computer on page 20.
Extra modules are required to connect all units to the
control computer.
Connection is via a CAN-bus, which allows different ac-
cessories to be connected, for example:
႑ up to 16 heating circuits.
႑ two hot water circuits.
႑ a buffer tank.
႑ solar heating system.
႑ extra boiler modules (exhaust fan).
႑
a lambda sensor.
NOTE
Remember to install a terminator at the end of the
CAN-bus to prevent an echo.
There must be a terminator on the CAN bus even if
only one module is connected to it.
The control computer is connected to the CAN bus and
the power supply according to the image below.
15 PELLUX 100
For the Installer
Electrical connections