WARNING
Do not block the tailpipes or exhaust ports. Do not situate the vehicle in a place where the exhaust gases have
any possibility of accumulating either outside, underneath, or inside your vehicle or any nearby vehicles.
Outside air movements can carry exhaust gases inside the vehicle through windows or other openings
remote from the exhaust outlet. Operate engines, carbon monoxide-producing systems, or components only
when safe dispersion of exhaust gases can be assured. Monitor outside conditions to be sure that exhaust
continues to be dispersed safely.
CARBON MONOXIDE (CO) DETECTORS
The detector is equipped with a “sensor activation strip,” which must be removed for the detector to operate properly.
This should have been done during the dealer’s Pre-Delivery Inspection. Please check the detector to verify that the
activation strip has been removed. The CO detectors are self-contained and do not require any maintenance other than
normal cleaning and dusting.
WARNING
Under no circumstance should you operate any engine while sleeping. When you are sleeping, you are not
able to monitor outside conditions to assure that engine exhaust does not enter into the coach. Check the
exhaust system frequently for damage. If damage is found, do not operate the system. Never modify the
exhaust system(s) in any way.
EMERGENCY EXITS
Provides step-by-step instructions for opening and closing emergency exit windows and doors.
HEHR EGRESS EMERGENCY EXIT WINDOW
Select Hehr windows have an opening window pane in the
egress window for ventilation. This style of window can also
be opened in the event of an emergency.
TO OPEN THE VENT:
1. Unclip and lower the arm.
2. Swing the arm 90 degrees, and push out on the
arm until the red handle latches.
TO CLOSE THE VENT:
1. Unclip the red handle from the latch by lifting
slightly while pushing outward.
2. Once the latch releases, pull the arm in until the
window is closed.
3. Rotate the arm 90 degrees until it latches into the
closed position.
IN THE EVENT OF AN EMERGENCY, OPEN THE WINDOW:
1. Remove the screen by pulling out on the red handle.
2. Push and release the lever from the locking hook.
3. Rotate the lever 90 degrees, and push it through the slot in the window frame.
4. Escape through the opening.
© 2018 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
15