1. Locate the slideout motor.
2. Remove the covers from the motor if it is located in
the wheel well area.
3. Loosen the trantorque bushing.
4. Turn the shaft with a wrench until the slideout
reaches the retracted position. Make sure you do not
damage the shaft with the wrench.
5. Retighten the trantorque bushing (175 ft. lbs. for 1"
shafts or 145 ft. lbs. for 3/4" shafts).
6. Reinstall any removed covers.
7. Take the coach to an authorized service center for
diagnosis and repair.
WARDROBE SLIDEOUT MOTOR
WITH SQUARE SHAFT
IF THE SLIDEOUT IS STUCK IN THE
EXTENDED POSITION
1. Remove the four mounting bolts, and move over the
slideout motor until it disengages from the square shaft.
2. Manually push the room in or out, or use a wrench to
rotate the shaft. Make sure you do not damage the shaft
with the wrench.
WITH MANUAL LOCK ARMS
3. Lock the room with manual lock arms (if equipped).
4. Take the coach to an authorized service center for
diagnosis and repair.
WITH MECHANICAL LOCK ARMS
3. Slide the motor back over onto the square shaft, and reinstall the four mounting bolts.
4. Wedge a 2x4" board between the slideout fascia and the exterior wall at the front and back of the slideout roof
to hold the slideout in the retracted position.
5. Take the coach to an authorized service center for diagnosis and repair.
NOTICE
Depending on the year, model, and floorplan of the coach, the exact slideout motor(s) location may vary.
Generally, they may be accessed from under the slideout in the compartment area. Some motors may also be
located in the wheel well area under a cover.
HWH HYDRAULIC SLIDEOUTS
1
© 2018 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
135