
IMPORTANT
Release cam might be rotated to any direction on the
valve. Make sure to move the release cams in the
correct direction. Incorrect movement of the cams
can damage the valves.
IMPORTANT
During normal operation of the room, do not reverse direction of the room until the room is fully extended. If
necessary, the direction of the room may be reversed, but watch for binding of the room. If the direction of the
room has been reversed, do not re-extend the room until the room has been fully retracted, as the room may
not drop to the level out position.
IMPORTANT
Do not hold the 'in' or 'out' switch for more than ten seconds after the room has stopped moving from the fully
retracted or fully extended position. If at any time the slideout stops or is in a bind, release the slideout switch
immediately. Do not force the room or reverse directions. Contact Newmar Customer Service for assistance.
HOW TO MANUALLY LIFT A HYDRAULIC FLAT
FLOOR SLIDEOUT
CAUTION
Contact Newmar Customer Service (1-800-731-8300) prior to manually lifting or retracting your Hydraulic Flat
Floor Slideout.
IMPORTANT
These brief operation instructions are for quick reference only. Any quick start instructions provided should
not take the place of the complete Operation Manual provided by this item's manufacturer.
NOTICE
Manual room lift procedures must be done before manual room retraction procedures.
1
1. Determine which synchronizing cylinder controls
the room. Manually open the valve release cams for
the extend and retract solenoid valves by moving the
cams to the "valve opened" position as shown.
If the pump manifold is equipped with an auxiliary hand pump, you may be able to retract the room by opening only the
room retract valve (as labeled by the wiring harness) and operating the hand pump, refer to the "Auxiliary Hand Pump
Operation" page (in your HWH Operator's Manual) for instructions on the use of the hand pump and valves equipped
with a release cam. If the room cannot be retracted with the hand pump, it will be necessary to use the lift bolts and
room retract screws.
© 2018 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
137