90
Options and programming methods
•
“
EXC
” (or “
ESC
”), to inhibit the control panel zones
•
“
INC
”, to activate the control panel zones
For the last two commands, the message text must be:
<xxxxxx> EXC <zone description>
where:
•
<xxxxxx> is the PIN of a control-panel user coded, followed by a blank space
•
“EXC” (or “ESC” or “INC”) is the command to be implemented on the zone, followed
by a space
•
<zone description> is the name zone to be inhibited or activated
6-29-2
Caller ID commands
The “Programming - Caller ID commands” section will allow you to programme up to
200 telephone numbers and the commands which will be implemented when each
telephone number is recognized by the control panel. If a voice call is received from a
telephone number, the command you select from those programmed in the “SMS
Commands” section will be carried out.
For the description of the programming parameters of each command, refer to the
SmartLeague Installation and Configuration Manual.
6-29-3
Text for SMS messages
The “Parameters settings - Customizable SMS Messages” section will allow you to create
up to 50 SMS text messages of 80 alphanumeric characters each. These messages can
be associated with the events by means of the “SMS message number/index” option
described in
paragraph 6-11 Events
.
6-29-4
General parameters
In the “Programming - General parameters” section, it is possible to programme some
functions relating to the management of the Nexus device, such as: low/remaining
credit, input and output volume, disablement of tamper protection and the emergency
signalling delay.
For the description of the general parameters, refer to the SmartLeague Installation and
Configuration Manual.
Note
The remaining credit control feature is subject to temporary or even permanent unavailability
caused by changes in the implementation of the methods used by the GSM/GPRS service
provider.
Ness provides device programming functions which may be capable of restoring this feature, by
means of manual changes to the respective parameter settings.
6-29-5
GPRS Connections
(Nexus/G only)
The Nexus/G allows you to use the GPRS connection for remote upload/download
operations to/from control panels using the SmartLeague software application.
The “Programming - GPRS Parameters” section allows you to configure the GPRS
communication settings of the Nexus/G device.
For the description of the general parameters, refer to the SmartLeague Installation and
Configuration Manual.
CONNECTION
Once the parameter settings are complete, you can activate the GPRS connection by
means of the following procedure:
1. Start the SmartLeague software application and access “Settings – Application
data” menu section.
Select “Connection via GPRS” from the “Communication Type” section, then press
“Start”.
2. The “Start” button opens the GPRS connection status window, where you must
the set port. The setting must coincide with the “Port” parameter, described
above.
3. Press the “Connect” button to activate the server.
4. The connection cannot be established until the teleservice request is received.
The teleservice request can be made in different ways, as follows.
TELESERVICE REQUEST
FROM KEYPAD
Select the “Nexus teleserv.” option from the User menu, then press the
button to
start the teleservice session.
