Installation and programming manual
Options and programming methods
89
7. Access programming of the selected code, at the “Assigned outputs” section.
8. Use keys
and
to select the outputs from those available on the list.
6-29
Programming the Nexus
The Nexus programming phase allows you to select which actions the control panel will
implement on receiving a voice call/SMS message (from an authorized user) over the
GSM network. Each command comprises a group of fully-programmable parameters.
Each time a user requests an operation - via a correctly formatted SMS message or
voice call to the SIM card of the Nexus - the control panel will activate the respective
shortcut/event and send confirmation (feedback) of the successfully implemented
command.
The following parameters can be programmed solely via the SmartLeague software
programme. Select the “Nexus” item from the SmartLiving system layout (on the left)
and then go to the “Programming” section on the right to programme the relative
parameters.
Note
Ness does not guarantee the total availability of all the GSM/GPRS functions described in this
manual, due to the various combinations of GSM/GPRS service providers, SIM types and
telephone models that may be in use.
6-29-1
SMS Commands
The “Programming - SMS Commands" section allows you to programme up to 30 SMS-
activated commands.
For the description of the programming parameters of each command, refer to the
SmartLeague Installation and Configuration Manual.
COMMAND USING SMS
TEXT
Users who wish to activate a command via SMS text must enter the command details as
follows:
<xxxxxx> <SMS Text>
where:
•
<xxxxxx> stands for the PIN of a control panel user
•
a blank space must be keyed in after PIN entry
•
<SMS Text> which is the command identifier, as previously described
EXAMPLE
You wish the control panel to activate “Scenario 3”, switch On the perimeter lights and
confirm the operation via SMS text. For an operation of this type, proceed as follows:
1. “SMS Text” - choose the desired description, for example “Night mode”
2. “Shortcut” - select the “Arm/Disarm” shortcut
3. “Shortcut option”: “Scenario 3”
4. “Shortcut 2” - select the “Activate outputs” shortcut
5. “Shortcut option 2” - the output associated with the perimeter lights
6. “Confirm” - SMS
When a user keys in the following SMS text on a mobile (cellular) phone:
123456 Night mode
where “123456” stands for the User's PIN and this message is sent to the number of the
SIM card of the Nexus, the control panel will carry out the requested operations and will
send an SMS message of confirmation to the mobile phone of the caller who dispatched
the command.
Night mode: command done!
DEFAULT COMMANDS
The installer by modify the five predefined default commands:
•
“
CREDIT
” for prepaid sims, for balance enquiries relating to the SIM card of the
Nexus - the user will receive an SMS text indicating the remaining credit.
•
“
STATUS
” for status enquiries relating to the Nexus - the user will receive an SMS
text indicating the:
•• device name and firmware revision
•• GSM network provider
•• GSM signal reception level
•• device tamper status
•• BUS status
•• Balance (remaining credit)
•• scenario active (if present)
