Nera WiLink-I 3000, Системное руководство

Страница: 65 / 250

Installing the Base Station Equipment
WiLink-I Modular Base Station System Manual 45
1
Firmly push in the module into its intended slot.
2
Press the handle down until you hear the locking click and the red button is
released.
3
Secure the module in place by closing the screw at the top of the front panel.
2.2.9.2 Ejecting Modules
1
Release the screws at the top and the bottom of the front panel.
2
Press the handles' red button until the handles are unlocked.
3
Wait until the blue HOT SWAP LED turns on, indicationg that the module has
been disconnected and can be removed.
4
Press the handles down (the upper handle)/up (the lower handle) until the
module is unlocked, firmly hold the handles and take the module out of the
chassis.
NOTE
If a module is fully inserted without properly locking the handles, it will become operational.
However, in this state the hot-swap mechanism is not supported. A warning message (trap) will be
sent.
To insert a PSU or a PIU without HOT SWAP support:
CAUTION
In a PIU without HOT SWAP LED, disconnect power from the PIU module before inserting it to the
chassis.
To eject a module with hot-swap support (NPU, AU-IDU, new PIU):
CAUTION
In a PIU with HOT SWAP LED, disconnect power from the PIU module only after it is taken out from
the chassis (or after the HOT SWAP LED is turned on).