NEC EXPRESS5800/120Lf, Руководство пользователя

Страница: 160 / 198

5-14 Problem Solving
Table 5-3. POST Error Codes and Messages (continued)
Error Code and Message Description Action
0232 Extended RAM
Failed at address
line. Extended RAM error Contact your service representative to
replace the system board or DIMM board.
0250 System Battery is
Dead - Replace and
Run SETUP. No battery is available for the
system. Contact your service representative to
replace the battery. (After battery is
replaced, start the SETUP utility to set
required values again.)
0251 System CMOS
Checksum Bad -
Default
Configuration Used Checksum of system CMOS is
not correct. The default values were set. Start the
SETUP utility to set required values again. If
the same error still occurs, call your service
representative.
0252 Password checksum
bad. Passwords
cleared. The passwords have been
cleared. Start the SETUP to provide password
settings again.
0260 System Timer Error. System timer error. Contact your service representative.
0270 Real Time Clock
Error. Real-time clock error. Contact your service representative.
0271 Check date and time
setting. Real-time clock is set incorrectly.
Start the SETUP utility and select [Main]
→
[System Time]
→
[System Date] to set the
correct time. If the same error reoccurs,
contact your service representative.
0281 Memory Size found
by POST deferred
from EISA CMOS. Memory size error. Contact your service representative.
02B0 Diskette drive A
error. Floppy disk A error.
02B1 Diskette drive B
error. Floppy disk B error.
Start the SETUP utility and select [Main]
→
[Diskette A] to set the required value again.
Check if the floppy drive cable is correctly
connected. If the error persists, contact your
service representative to replace the cable
or floppy disk drive.
02B2 Incorrect Drive A
type - run SETUP. The type of drive A is incorrect.
02B3 Incorrect Drive B
type - run SETUP. The type of drive B is incorrect.
Start the SETUP utility to set required values
again. If the error persists, contact your
service representative to replace the cable
and/or drive.
02D0 System Cache error
- Cache disabled. System cache error - Cache
disabled. The cache cannot be
used.
02D1 System Memory
exceeds the
CPU's caching limit. System Memory exceeds the
CPU's caching limit.
Contact your service representative.
02F4 EISA CMOS not
write enabled.
02F5 DMA test failed.
02F6 Software NMI failed.
02F7 Fail-safe timer NMI
failed.
Contact your service representative.