NEC EXPRESS5800/120Lf, Руководство пользователя

Страница: 119 / 198

Upgrading Your System 4-33
Installing a 5.25-Inch Media Device
To install a 5.25-inch media device, perform the following procedures:
1. Observe the safety and ESD precautions listed under General Information
and Static Precautions at the beginning of this chapter.
2.
Prepare your system for upgrade. See Preparing Your System for Upgrade
described earlier in this chapter.
3. Remove the left-hand side access panel as described earlier in this chapter.
!
CAUTION
Observe static precautions. Use an antistatic wrist strap.
4.
Remove the dummy cover from the bay where you are installing a media
device. The dummy cover is released by removing the two screws holding it
in place (see Figure 4-30). Save the dummy cover and screws for future use.
Note:
When installing a full-height device, remove two
dummy covers.
Figure 4-30. Removing the Dummy Cover
5.
Remove the device from its protective wrapper and place it on an antistatic
surface. Record the drive model and serial number in the equipment log.
6. Set any drive jumpers or switches before you install the drive. See the
documentation that comes with the device for jumper or switch information.
7. Attach the mounting rails to the device with the four screws that come with
the device, as shown in Figure 4-31.
Note:
If the drive comes with drive rails, do not use
them. Remove any rails already attached.