Configuring Your Server 4-9
USB Mass Storage Device Configuration submenu
Option
Parameter
Description
Your Setting
USB Mass Storage
Reset Delay
10 Sec
[20 Sec]
30 Sec
40 Sec
Number of seconds POST waits
for the USB mass storage device
after start unit command.
Device #1
Device
Display only. Displays the USB
mass storage device detected by
BIOS.
Emulation Type
[Auto]
Floppy
Forced FDD
Hard Disk
CDROM
If Auto, USB devices less than
530MB will be emulated as
Floppy and remaining as hard
drive. Forced FDD option can be
used to force a HDD formatted
drive to boot as FDD (Ex. ZIP
drive).
[ ]: Factory-set
PCI Configuration submenu
Option
Parameter
Description
Your Setting
Onboard Video
Disabled
[Enabled]
Enables or disables the onboard
video controller.
Dual Monitor Video
[Disabled]
Enabled
Select which graphics controller
to use in as the primary boot
device. Enabled selects the
onboard device.
Onboard NIC 1
(10/100/1000)
Disabled
[Enabled]
Enables or disables the onboard
network interface controller.
Onboard NIC 1
(10/100/1000) ROM
Disabled
[Enabled]
Enables or disables the option
ROM scan for the onboard
network interface controller.
Slot 1 Option ROM
Slot 2 Option ROM
Slot 3 Option ROM
Slot 4 Option ROM
Slot 5 Option ROM
Disabled
[Enabled]
Initializes device expansion
ROM.
[ ]: Factory-set
Содержание Express5800/120Eg
