9-24 Upgrading Your Server
Using Internal Disks in Disk Array Configuration
For the installation of the RAID controller board, see "PCI Board" and the manual that comes with
the RAID controller board. The DISK access lamp on the front panel of the server indicates the
access status of the hard disk drive connected to the RAID controller board. Before the access status
can be indicated, the LED connector on the RAID controller board and the LED connector on the
mother board must be connected through the LED cable supplied with the server.
Mother Board
The LED connector is at the position shown in the figure below. It can be connected in
either direction.
RAID Controller Board
The red cable of the LED cable comes out from the connector hole. Connect the connector
hole to "LED Active" of the LED connector on the RAID controller board. For the
position of the LED Active pin, see the manual supplied with the RAID controller board.
Use the interface cable supplied with the RAID controller board. Disconnect the current cable from
the server and keep it in a designated place. For details on the cable connection, see the manual
supplied with the RAID controller board.
After installing the RAID controller board, make settings such as RAID setting, using the disk array
BIOS utility of the RAID controller board. For details on the setting procedures, see the manual
supplied with the RAID controller board.
Face this side
upward.
To the mother board
LED cable
To the RAID
controller
Connect 2-pin LED cable.
Содержание Express5800/120Eg
