Navien NPE-180A, Руководство по обслуживанию

Страница: 85 / 171

Version 2.21 84 NPE Service Manual
Check method
Fault
Possible
Causes
Check method
Flame loss and noise
occurs after ignition
Low gas
supply
pressure
1. Check the gas supply pressure.
●
NG: 3.5” - 10.5” W.C, LP: 8” - 13” W.C
●
LP pressure drop occurs frequently in the winter.
2. While the static pressure is normal, the use of another gas appliance may cause a possible
drop in gas pressure to the unit. Therefore, it is required to check the dynamic pressure.

Check the static pressure: Gas supply pressure during stand by.
Check the dynamic pressure: Gas supply pressure at (2nd stage MAX combustion setting:
DIP S/W 1-1 ON) MAX combustion
3. Check the gas pipe connector.
●
If a CSST connector has been used, check to ensure that it is not been overtightened
resulting in the seal obstructing gas flow.
4. Check the gas meter capacity (Example)
●
Gas meter Water heater Furnace Domestic gas stove
425 CFH (Gas Meter) ≥ 195 CFH (Water 58.8 CFH (Furnace)
+ 63.7 CFH (Domestic gas stove)

1 CFH = 1,020 Btuh
5. If too much pressure is exerted on the nut component while installing the gas pipe may
reduce the gas supply due to packing push-out and Teflon blockage, etc.