Service Manual Chapter7. Cash Dispenser Unit
© 2013
Nautilus Hyosung Inc.
All Rights Reserved.
7-31
Bill Withdrawal Detection Sensor (CS15)
► Bill Withdrawal Detection Sensor (CS15)
1. Loosen M3 fixing screw (1 place) of the Sensor Bracket.
2. Disconnect the connector and remove the cable tie to remove the Sensor Bracket.
Be careful not to break the connector pin when removing.
3. Remove the black rubber which attached to back of the Sensor Bracket.
4.
Press the part ‘B’ of the sensor softly as shown in the figure below to remove the
lock and the sensor.
5. Replace the sensor.
6. Assemble this in the order of 4~1. To insert the senso
r, insert the part ‘A’ first and
press the part to lock.
