Service Manual Chapter7. Cash Dispenser Unit
© 2013
Nautilus Hyosung Inc.
All Rights Reserved.
7-47
► Drive Belts Tension between Feed Modules (3 places)
1. First, place the belt in the direction shown in the diagram below, and assemble the
Idle Tension Bracket at the end of the assembly process.
2. Put the embossing behind the Idle Tension Bracket inside the square home, and
push it in the direction of the arrow. Slightly snug the M4 screw.
3. Adjust the Idle Tension Bracket so that the belt tension at the longest belt point has
the tension of about 400~600g and then tighten the screw completely. Make sure the
screw is not loose which can loosen the belt tension.
4. Slowly turn the Green Knob and double check if any belt vibration exists.
