National ramp ALUMINUM SOLID, Руководство по установке

Страница: 108 / 138

20.5  Set the final 6' ramp section and 1' BTP.
20.5.1.
Place the section upright on sawhorses, with the tongue side facing forwards.
20.5.2.
Slide the Bottom Transition Plate (BTP) into the groove end of the ramp section.
20.5.3.
Attach universal brackets and bolts for the two (2) sets of handrails needed for this final
section.
20.5.4.
Mount the handrails, hand-tightening the bolts to allow for later adjustments.
20.5.5.
Carry the ramp section over and attach the tongue side into the groove of the platform.
20.5.6.
Using a level, make sure the ramp section is level across the ramp and at the correct slope.
Make sure the BTP is fully supported and firmly on the ground across its length.
TIPS AND TRICKS
Legs are not needed unless there is a cross slope requiring a leg on one side to
level the ramp section across the width.
image 97
A A
B B
C C
D D
E E
F F
1
1
OF NATIONAL RAMP.
1. FOOT PLACEMENT DIMENSIONS MUST BE VERIFIED BASED ON FIELD CONDITIONS AND ACTUAL INSTALL
[ 108 ] NATIONAL RAMP
™
| FREEDOM NOW
www.nationalramp.com | 877-884-RAMP(7267)
Tongue, Top
Groove,
Bottom