National ramp ALUMINUM SOLID, Руководство по установке

Страница: 121 / 138

21.4.3.
Measure the leg heights.
21.4.4.
Mount the legs to the platform – snug the bolts without over-tightening.
21.4.5.
Carry the platform over and attach the tongue side into the groove of the ramp section.
21.4.6.
Using the level, adjust the legs so the platform is level, at the correct height and the legs are
plumb.
21.4.7.
Insert the switchback bracket with bolts into the inside corner of the platform coming off
the ramp. Using the holes in the switchback bracket as a guide, drill into the groove section
of the platform.
21.4.8.
Mount the leg to the bolts of the switchback bracket.
21.5

Set the second 5'x5' turn platform.
21.5.1.
Repeat steps 1-6 of Step 4; however, there will only be two (2) legs placed opposite the
tongue.
21.5.2.
Install toe guards. Place toe guards along the inside edges of the platform, and affix each
with two (2) driller screws.
TIPS AND TRICKS
While it is recommended for the platform to be installed completely level, the
platform can be installed at up to a 1° angle to allow for rain runoff.
A A
B B
C C
D D
E E
F F
1
1
OF NATIONAL RAMP.
1. FOOT PLACEMENT DIMENSIONS MUST BE VERIFIED BASED ON FIELD CONDITIONS AND ACTUAL INSTALL
[ 121 ]
Liberty Series™ Ramp Installation Guide-Revision 8/1/2020
image 116
TW
O LA
Y
OUT C
ONFIGURA
TIONS S
T
AR
T T
O FINISH
Tongue, Top