National ramp ALUMINUM SOLID, Руководство по установке

Страница: 43 / 138

[ 43 ]
Liberty Series™ Ramp Installation Guide-Revision 8/1/2020
All platforms have three sides with a groove and one with a tongue, while all ramp sections have one
tongue and one groove. The tongue side of the ramp or platform section hooks onto the groove of
the section ahead. A ramp or platform section can hook onto any platform groove side.
Platforms can be attached to each other to create configurations allowing for wider turns, to extend
over an obstacle, or to change the direction of the ramp 180°.
The slip-resistant treads always run horizontally in the direction that the ramp runs as you travel
down the ramp from the entrance. The treads are in sets six inches long. The treads on the platform
run parallel to the tongue side, and platforms are always measured starting with the width: A 5'x4'
platform is 5' wide and 4' long, while a 4'x5' platform is 4' wide and 5' long.
All legs, handrails, T-Posts, etc. attach to its ramp or platform with the use of universal brackets.
To determine if a ramp layout is turning left or right, describe it as if you were traveling down the
ramp from the home entrance.
BEFORE YOU INSTALL:
Review the packing list before leaving for the job site to make sure everything needed was in the
shipment.
Confirm that the measurements taken at the evaluation are accurate and that the property has not
changed in a way that will impact the installation.
Lay out all main components in the general area that they will be going, starting with the top of the
ramp. Place all handrails next to each platform and ramp section. Place all hardware bags on each
section or platform. Confirm that all components are on-site and undamaged.
Complete any needed site prep.
O
VER
VIEW OF THE LIBER
TY SERIES
TM
S
Y
S
TEM