National ramp ALUMINUM SOLID, Руководство по установке

Страница: 112 / 138

20.10.1.1.
Line up a 4' level on the end of each ramp section vertically, making sure it is
plumb, and make cut marks on the top and bottom of each handrail.
20.10.1.2.
Cut the handrails using the pipe cutter, clearing any burrs.
20.10.1.3.
Attach the elbows to both handrails and point the loose ends towards each other.
20.10.1.4.
Line up filler pipe with the elbow on one side, scoring the cut mark on the other
side. Repeat this for the lower handrail.
20.10.1.5.
Cut the pieces of filler pipe and attach it between the handrails.
20.10.2. Opti on 2  T-post
20.10.2.1.
Install the vertical support of the T-Post as close to the corner as possible.
20.10.2.2.
Starting with the inside corner of the T-post, insert elbows into the ramp handrails,
and measure the cut mark on the T-post.
20.10.2.3.
Cut the handrails using the pipe cutter and connect the elbows after clearing any
burrs.
20.10.2.4.
Insert elbows on the outside corner of the T-Post and ramp handrails, and measure
filler pipe to fit between the elbows, using a right angle or triangle to make sure
the railings will be at 90°.
20.10.2.5.
Cut the handrails using the pipe cutter and connect the elbows after clearing any
burrs.
A A
D D
N N
R R
DRAWN
A A
D D
N N
R R
DRAWN
T-Post
[ 112 ] NATIONAL RAMP
™
| FREEDOM NOW
www.nationalramp.com | 877-884-RAMP(7267)
image 102
Groove,
Bottom
Tongue, Top