NARDA IDA, Руководство по эксплуатации, Страница: 95 / 292

Narda IDA - 3106
87
5.4.5 Changing the switch on behavior
Main Menu • Setups
You can specify the measurement settings to be used by the device when it
starts up after being switched on:
•
Factory Setup
: The default factory setup (state as supplied) is used.
•
Last Settings:
The settings in use at the time the device was last
switched off will be used (default after reset).
•
Power On Setup:
The setup marked in the
Setups
menu as the
Power on Setup
will be used.
To select the settings:
1.
Press the
Power on Settings
softkey.

The selection window opens.
2.
Mark the desired function using the rotary control knob and press
OK
to
confirm.
To select a setup as the Power on Setup:

Mark the desired setup in the list using the rotary control knob and then
press the
Mark Power on Setup
softkey.

The selected setup is marked in the list (‹‹...››) and will be loaded the
next time you switch on the instrument.
5.5 The memory menu
Main Menu • Memory
The following functions are contained in the Memory menu:
• Display data sets (Data Viewer)
• Display saved screenshots (Screenshot Viewer)
• Output of recorded demodulated signal content (Demod. Record Viewer)
• Set comment function
• Save data to microSD memory card in csv format
• Configure automatic storage (Time Controlled)

You can find detailed information about all these functions in chapter 13
Measurement Data Memory
on page 219.