MUTOH Viper Extreme, Руководство пользователя

Страница: 32 / 148

User’s Guide Viper Extreme
CHAPTER 3: Basics
32 AP-75330 – Rev. 1.0 – 14/01/09
3.3.4 Using the ETT system
The ETT Extra Tension Tool pulls the media in line with the print platform. The tension on the sides is always
bigger than in the middle. As a result possible curls are straightened.
Step 1 : Make sure there is no media loaded in the printer. Bring the ETT-holding-bar forward. (Handle is
placed horizontal.)
Step 2 : Install the ETT’s on the ETT-holding-bar.
Notes
Make sure to correctly install the extra tensioning tool (ETT)
There are three different ETT’s: a Left-ETT, a middle-ETT and a Right-ETT.
Please note that the outer sides of the Right and Left-ETT have longer springs than the insides!
Place the PE-strip over the transitions between the different ETT segments
Only use the middle part of the ETT if medi a width is larger than 44” (for 65” printer)
Only use the middle part of the ETT if medi a width is larger than 51” (for 90” printer)
Step 3 : Secure all ETT’s to the ETT-holding-bar with the secure knob.
Step 4 : Put the ETT in the backwards position (place the handle vertically).