MUTOH Osprey 102, Руководство пользователя

Страница: 84 / 176

User’s Guide – Osprey 75/102/130
Chapter 5: Preparations before printing
84 AP-75102, Rev. 2.0, 28/11/2007
Step 2:
Align the alignment line on the media retainers to the edge of the media with, and install the media
retainers on the platen as shown on the image below.
No. Name
1 Roll media
2 Media retainers
3 Alignment line
4 Platen
Notes
•
When installing the media retainers, be sure that the magnet in the rear does not stick out from the
stainless steel part of the platen to prevent that the media retainers will come off and interfere with the
print head.
Step 3:
Make sure that the media retainers do not interfere with the media as it is fed through the printer.
Notes
•
If there is interference with the media as it is fed through the printer even after the media holder plate
has been installed, the media retainer should not be used.
•
When removing the media retainer, slide the plate on the platen for near side.
5.1.8 Head cleaning before printing
Be sure to read and understand the safety warnings before handling the printer.
When used?
Before printing, perform purge and head cleaning to clean the print head surfaces and the nozzles.
Procedure:
The procedure consists of 2 parts.
1. Perform a purge
Step 1 :
Switch ON the printer.
Step 2 :
Verify the product is in the normal status.
Step 3 :
Press the [F4] key of the control panel. See below.