Configuring TRAIL-Control
Configuring automatisms when driving in reverse
6
30322332-02-EN
V2.20160912
33
If the steering system is actuated during the centering procedure, the centering is aborted. The
system remains in manual mode.
For activation, mark the box near these icons.
Centering when tapping the centering icon
When you are working in automatic mode and tap the
or
function icon, the
system automatically centers the trailed implement. To do so, the system is switched to manual
mode. In addition, you can define after how many seconds the automatic mode should be
reactivated.
For activation, mark the box near these icons.
Configuring automatisms when driving in reverse
Several tractors can send a signal through the ISOBUS to all ISOBUS job computers when the
reverse gear is engaged. TRAIL-Control can then detect a reverse driving signal and react to it.
As a standard, TRAIL-Control stops working if a reverse driving signal is detected. In this case, the
automatic mode remains activated, but the hydraulic valves are not being controlled.
You can configure how TRAIL-Control should react when a reverse driving signal is received.
To activate the automatisms:
1.
Switch to the "TRAIL Control" screen:
2.
- Press.
⇨
The following screen appears:
⇨
An automatism is described on each line. On the left, you can see the conditions under
which a mechanism is executed. On the right, the effects.
3.
To activate functions, set the check mark on the desired line. These functions will be explained in
the following sections.
6.5.3
6.6
Procedure
