Mounting and installation
Checking the installation position of sensors
4
30322332-02-EN
V2.20160912
15
Using the gyroscope
1.
Fasten the gyroscope into the bracket on the tractor and screw tight with the wing screw.
The side with the
TOP-OBEN
label must be on the top:
2.
After work, fasten the gyroscope into the bracket on the trailed implement and screw tight with
the wing screw.
Checking the installation position of sensors
The system is capable of measuring the voltage on the sensor input of the job computer and
displaying it on the screen.
This allows you to check whether selected sensors are properly installed.
Sensor voltages
Sensor type
Position during measurement
Correct voltage
Angle sensor
Center position: The drawbar (or wheels of the trailed
implement) is (are) aligned to drive straight ahead.
2.5V
(+/- 0.1V)
Voltages when the trailed implement is steered to the
maximum left or right.
Approx. 1.5V and
3.5V
(+/- 0.1V)
Short circuit:
0.1V
Slope sensor
The trailed implement is standing on level ground.
2.5V (+/- 0.1V)
Gyroscope
Sensor is in the bracket on the tractor. The tractor is at a
standstill.
2.5V (+/- 0.1V)
This allows you to check whether the sensors are properly installed:
The diagnostic function was activated during the initial configuration.
Start screen is called up.
4.1.2
Procedure
4.2
Procedure
