6
Configuring TRAIL-Control
Calibrating TRAIL-Control
28
V2.20160912
30322332-02-EN
5.
- Steer the trailed implement fully to the right.
6.
- Start calibration.
⇨
The following message appears:
"Most right position: the calibration is ready"
7.
- Confirm within 3 seconds.
⇨
Calibration is initiated.
⇨
The following message appears:
"Most right position: the calibration is running"
8.
Wait until the message "Most right position: the calibration is running" is no longer displayed.
⇨
Phase 2 of calibration has been completed.
Calibrating the hydraulics of the proportional valve
You must only calibrate the hydraulics of the proportional valve when you use a trailed implement
with proportional valve.
WARNING
Danger of injury from trailed implement movement
When calibrating the proportional valve, the trailed implement moves automatically.
This may pose a risk to you and to persons in the immediate vicinity of the trailed implement.
◦ Ensure that nobody is in the regulation range of the trailed implement.
◦ Abort the calibration with the
function key as soon as someone approaches the
trailed implement.
TRAIL-Control is in manual mode.
Ground is not sloped. Slope sensor must not recognize any slope. Otherwise the "Slope counter-
steering" will not work properly.
You have enough space to drive straight ahead for about 30 seconds.
1.
Switch to the "TRAIL Control" screen:
6.3.2
Procedure
