Moxa Technologies ioLogik E2210, Руководство пользователя

Страница: 45 / 144

ioLogik E2200 Series Using ioAdmin
3-14
Messages can be displayed in ASCII or in HEX. To display messages in HEX, make sure that “Toggle HEX” is
checked.
Sync Rate Status
The current sync rate is displayed on the bar at the bottom of the window. The number shows how often the
ioLogik is polled for device status from the ioAdmin utility. The rate can be adjusted by clicking Menu Bar

System

I/O Status Refresh Rate
NOTE The higher sync rates result in higher loads on the network.
Status Bar
The status bar shows ioAdmin status information, such as program ready, searching ioLogik I/O, time, etc.
ioAdmin Administrator Functions
For full access to all configuration options, log in as an administrator in the Server Settings tab. This is required
whenever you start up ioAdmin or boot up/restart the ioLogik. When you install the ioLogik for the first time,
the password will be blank and you can simply click Login . Additional functions will available after logging in,
including the following new tabs:
When making configuration changes, you will need to click Update or Apply to save the changes. Some
changes will require that the unit be restarted in order to take effect.
1. I/O Configuration
2. Server Setting (Admin)
3. Network
4. Firmware Update
5. Click&Go Logic
6. Watchdog
7. Active Tag
8. SNMP Setting
9. Message Monitor
ATTENTION
You MUST log in to access administrator functions, including Network, Communication Watchdog Timer, and
Firmware Update tabs. If you forget the password, hold down the reset button to clear the password and load
factory defaults. This will result in the loss of all configuration settings and your Click&Go logic rules
that have already been configured.