Mountain Models Tantrum
13
6.
Glue all of the joints, and once dry remove them from the wax paper.
7.
Create a 45
°
°
bevel into the leading edge of both aileron assemblies. This should ONLY
be done on one side.
To get a left and a right aileron, make sure you lay out the ailerons so
that both leading edges are facing forward, mirroring each other.
Ailerons with Bevel Guide
Step 4: Assembling the Wings
Once you've finished building the tail feathers and the ailerons, you can begin
assembling the wings. The wings are not interlocking, but do have guides to help you
make sure things go together correctly.
The information within this section applies to building one
wing at a time and then duplicating the entire process for the other wing. But if you
want to, you can build both the wings at the same time.
You must be sure to
make a right and a left wing. This is a good reason to at least
start the two wings at the same time.
Attaching the Wing Root and Tip Ribs to the Vertical Spar
For each wing, you will need:
•
1 wing tip rib (Figure B)
•
1 vertical spar (Figure C)
