Motorola RFS Series, Справочное руководство системы

Страница: 323 / 590

Switch Services
5-41
5.4.3 Configuring Redundancy Group Membership
The redundancy group should be disabled to conduct an Add/Delete operation. There are a minimum of 2
members needed to comprise a Redundancy Group, including the initiating switch
To configure switch redundancy memberships:
1. Select Services > Redundancy from the main menu tree.
The Redundancy screen displays with the Configuration tab selected.
2. Select the Member tab.
3. Refer to the following information within the Member tab:
IP Address Displays the IP addresses of the redundancy group member.
Status Displays the current status of this group member. This status could have the
following values:
• Configured - The member is configured on the current wireless service module.
• Seen - Heartbeats can be exchanged between the current switch and this
member.
• Invalid - Critical redundancy configuration parameter(s) of the peer (heartbeat
time, discovery time, hold time, Redundancy ID, Redundancy Protocol version
of this member) do not match this switch’s parameters.
• Not Seen - The member is no more seen by this switch.
• Established - The member is fully established with this current module and
licensing information already been exchanged between this switch and the
member.
• Unknown - No status information could be obtained.
Last Seen Displays the time when this member was last seen by the switch.
AP Adoption Count Displays the number of Access Ports adopted by this member.
AAP Adoption Count Displays the number of Adaptive APs adopted by this member.