Moore Industries NET Concentrator System AOM, Руководство пользователя

Страница: 49 / 103

- 49 -
Moore Industries-International, Inc.
www.miinet.com
NET Concentrator System
®
Input/Output Modules
NCS-I/O
Hot-Swapping an I/O Module
Should an external Input/Output Module need to be
replaced, you do not need to power down the Interface
Module. Instead, simply remove the old module from
the terminal base, and snap in the new one.
Programming a New Module
The Interface Module uses the configuration present
in the new module. If the new module has the same
configuration as the one being replaced, nothing else
needs to be done. If not, the new module must be
programmed using the directions in the configuration
section.
Removing the Old Module
For older units with two clips, begin by taking two
small flat-head screwdrivers and inserting each under
a different base clip, as shown in I/O Modules
Figure 2. With the base clips pulled away, pull the
module out from the base. Newer units have only one
base clip, as shown in I/O Modules Figure 3.
I/O Modules Figure 2. Removing the Old Module
Step 1:
Gently pull base clips
away from base
Step 2:
With base clips
pulled away,
pull module
out from base.
Base
Clip
Step 1:
Gently pull base clips
away from base
Module
Number
Keying post Keying hole
Base
(Internal View)
Module
(Back View)
I/O Modules Figure 3. Snapping in a New Module
Snapping in the New Module
Check to see that the keying post (shown in
I/O Modules Figure 3) will line up properly with the
keying hole in the bottom of the module. If it does not,
rotate the module 180°. If it still does not line up, the
module is of the wrong type. The new module must
be of the same type as the previous module.
Slip the new module into the base from which the old
one was removed. Push it firmly into position. The
lights on the face of the input/output module should
glow as the unit powers up. Your new I/O module is
now in service.
Note:
A new I/O module will only work with an identical type
of base. The new module must replace an identical
older module.
Note:
Earlier Models have a different DIN
latch but overall dimensions are the
same and both versions are interchangeable.