19
TM SmartCool One 5057724 v1.0_08_2022
General
Features
System Configuration
SO09
SO12
SO15
SO18
SO22
SO25
SO31
SO35
SO30
SO40
SO50
SO60
General
Open Discharge Floor Stand
● ● ● ● ● ● ● ● ● ● ● ●
Rear Discharge Floor Stand
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Front Discharge Floor Stand
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Base Discharge Floor Stand
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Above Floor Void Floor Stand with Lowered Door Display
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Floor Stand Extended Legs
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Plinth / Seismic Plinth
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Actuated Non Return Dampers
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Ceiling Duct Extension
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
●
Standard Feature
○
Optional Feature
–
Not Available
Floor Stand Options
The open discharge floor stand configuration is offered as standard, complete with adjustable feet and floor tile lip. Rear,
front or base discharge floor stands are available as options. Please specify the height of the floor stand at order.
The unit and floor stand has been designed to allow for both above and below floor void installations. The floor stand
has options for open, front or rear air discharge for both above or below floor void installations, whilst the base discharge
option is only available on above floor void applications.
The standard floor stand design can allow up to a total height of 1m by extending the legs when specified at the time of
placing an order. In some instances, it may be preferred to maintain a standard floor stand height and install the unit and
floor stand onto a plinth located in the floor void.
Plinths
The SmartCool One range has a standard range of welded steel plinths, as well as seismic plinths with increased
structural support for seismic applications. Please contact Airedale to discuss the range of options available.
Actuated Non-Return Dampers
The unit actuated non-return damper option prevents recirculated air in the data centre when the unit is off, by closing
the non-return dampers. The option has been designed to mount directly to the top of the unit case. If it is required that
a custom damper is to be fit upstream and controlled by the unit, then this is possible providing that the actuator of the
damper meets the same requirements as the standard offering. The actuated non-return damper may effect maximum
unit performance and efficiency. Please contact Airedale for more information if this is required.
Ceiling Duct Extension
Straight and ‘L’ shaped duct extensions up to a height of
1350mm
(53.2”), constructed and finished to match the unit,
are available. Please specify the required height at order, and for extensions greater than
1350mm
(53.2”) please
contact Airedale for more information.
Precision Air Conditioning
SmartCool™
Introduction
