MobileView PENTA, Руководство по установке

Страница: 31 / 114

Chapter 3: DVR installation
MobileView PENTA Installation Manual 25
2. With the vehicle power off, make connections to the vehicle power and
ignition sources.
Contact the vehicle manufacturer for information on connecting to the vehicle
power source.
3. At the DVR, remove the J1 connector and terminate each wire to the proper
terminal as shown in Figure 18 on page 24.
4. Before reattaching the J1 connector, turn on the power and use a voltmeter to
check each terminal for proper voltage and polarity.
Main power and ignition voltages should be nominal 12 or 24 VDC.
Note: MobileView PENTA supports nominal SAE base vehicle voltages of 12
and 24 VDC.
5. After confirming voltages and polarities are correct, remove the power, plug
the connector into the J1 receiver, and then tighten the retaining screws.
J1 harness connections
The J1 harness couples a 6-pin Molex type connector to the J1 connector
(Figure 19 below). This arrangement provides dedicated termination points for
main power, ground, and ignition. Common and specific usage of each
termination point is provided in Table 1 below. Looping outputs are generally
used to power and control the MobileView wireless network transmission device.
Figure 19: Main power connection
Table 1: J1 harness pinout
6-pin Molex Color Use J1 block
1 Red Main power in J1.1
2 Black Return in J1.2
3 White Ignition in J1.3
4 Red Main power out J1.1
5 Black Return out J1.2
6 White Ignition out J1.3