Mitsubishi GOT2000 Series, Руководство по подключению

Страница: 316 / 674

9 - 28 9. MELSECNET/H CONNECTION (PLC TO PLC NETWORK), MELSECNET/10 CONNECTION (PLC TO
PLC NETWORK)

[Network parameter] of GX Developer
(1) Network parameter
: Necessary : As necessary : Not necessary
*1 Specify the same network No. as that of the network number
setting switch of the MELSECNET/10 network module.
(2) Network range assignment
: Necessary : As necessary : Not necessary
*1 Be sure to set it to perform the cyclic transmission.
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the PLC CPU,
operate the PLC CPU ether turning OFF and then ON
or resetting.
Item Set value
Setting
necessity at
GOT
connection
Network type
MNET/10
(Control station) (fixed)
Start I/O No. 0000
H
Network No.*1 1
Total stations 2
Network range assignment Refer to (2)
Refresh parameters
(Use default value)
Interlink transmission
parameters
Routing parameters Refer to (3)
Item Set value
Setting
necessity at
GOT
connection
Monitoring time 200
BW
setting
*1
Send
range
for
each
station
(LB)
Station
No.1
Start 0000
H
End 00FF
H
Station
No.2
Start 0100
H
End 01FF
H
Send
range
for
each
station
(LW)
Station
No.1
Start 0000
H
End 00FF
H
Station
No.2
Start 0100
H
End 01FF
H
XY setting
*1
No setting
Specify I/O master station*1 No setting
Specify reserved station No setting
Supplementary setting
(Use default value)
Station inherent parameters