Mitsubishi FB13PNT, Быстрый старт

Страница: 242 / 292

3-17 3-17
)) pp y pp y (( y, y, g g ))
the clearance between the terminal and the clearance between the terminal and stator core. stator core.
2) 2) 11± 1 N 11± 1 N·m ( 1 ·m ( 1.12 ± 0 .12 ± 0.1 kg .1 kgf·m f·m) [ 8. ) [ 8.11 ± 0. 11 ± 0.74 lb 74 lbf·f f·ft] t]
)) pp y pp y ,, q q p p
in M8 thread holes.] in M8 thread holes.]
4) 4) Secu Secure t re the t he tempe emperatu rature s re sensor ensor using using Arald Araldite ite (epo (epoxy xy
paste adhesive AV/HV1580 or equivalent). paste adhesive AV/HV1580 or equivalent).
Replacing Temperature Sensor Replacing Temperature Sensor
By cutting off the By cutting off the wire of the current temperature sensor (no wire of the current temperature sensor (no
need to remove the sensor), a new temperature sensor can need to remove the sensor), a new temperature sensor can
be mounted on the opposite side.
be mounted on the opposite side.
Use Araldite (epoxy paste adhesive AV/HV158 or equivalent) Use Araldite (epoxy paste adhesive AV/HV158 or equivalent)
to secure the temperature sensor.
to secure the temperature sensor.
1. 1. New tem New temperat perature se ure sensor nsor
2. 2. Curre Current tempera nt temperature senso ture sensorr
3. 3. Cu Cut o t off ff
1 1
2 2
3 3
502713 502713
CHAPTER 3 MOTOR CHAPTER 3 MOTOR
12. 12. Tight Tightening ening of Hi of High-pow gh-power Ca er Cable ble Term Terminals inals
CAUTION CAUTION
If the high-power cable terminals of the battery-operated If the high-power cable terminals of the battery-operated
vehicle are not tightened properly, the increased contact vehicle are not tightened properly, the increased contact
resistance causes excessive heat generation, and could resistance causes excessive heat generation, and could
cause a fire in the worst case. To prevent accidents and
cause a fire in the worst case. To prevent accidents and
equipment problems, be sure to regularly check the
equipment problems, be sure to regularly check the
tightening torque of the high-power cable terminals. Do not
tightening torque of the high-power cable terminals. Do not
pull the cables to check connections or during adjustment.
pull the cables to check connections or during adjustment.
If the cable terminal sections are moved, re-tighten the
If the cable terminal sections are moved, re-tighten the
connections.
connections.
1. 1. Left Tr Left Tractio action motor (3 n motor (3
terminals) terminals)
2. 2. Right T Right Tracti raction moto on motor (3 r (3
terminals) terminals)
502730 502730
1 1
2 2
1. 1. Pump m Pump motor (3 te otor (3 termina rminals) ls)
502731 502731
1 1