27
BCN-B11127-479*
6. Display and Operation
6.1 Display flowchart
Use the display (5-digit, 7-segment LED) on the front panel of the servo amplifier for status display,
parameter setting, etc. Set the parameters before operation, diagnose an alarm, confirm external
sequences, and/or confirm the operation status. Press the "MODE" "UP" or "DOWN" button once to move
to the next screen.
To refer to or set the expansion parameters, make them valid with parameter No. 19 (parameter write
disable).
Current position
[pulse]
Command position
[pulse]
Command remaining
distance [pulse]
Regenerative load
Within one-revolution
position low [pulse]
ABS counter
[rev]
Load inertia moment
Ratio [times]
Communication status
Sequence
External I/O
signal display
Output signal
forced output
Test operation
Jog feed
Test operation
Positioning operation
Test operation
Motor-less operation
Current alarm
Last alarm
Second alarm in past
Third alarm in past
Fourth alarm in past
Fifth alarm in past
Sixth alarm in past
Parameter error No.
MODE
button
DOWN
UP
Software version L
Software version H
Status display
Diagnosis
Alarm
Expansion
parameters 3
Parameter No. 50
Parameter No. 51
Parameter No. 89
Parameter No. 90
Instantaneous torque
Within one-revolution
Bus voltage [V]
Test operation
Machine analyzer operation
Motor series ID
Motor type ID
Encoder ID
Cumulative feedback
pules [pulse]
Motor speed
[r/min]
Droop pulses
[pulse]
Peak load ratio
ratio [%]
[%]
Effective load ratio
[%]
[%]
position high [pulse]
Network I/F unit
S/W version L
Network I/F unit
S/W version H
Target position
Motor speed
Acc. time
Dwell time
Parameter No. 0
Parameter No. 1
Parameter No. 18
Parameter No. 19
Basic
parameters
Point table No.1
Point table No.2
Point table No. 30
Point table No. 31
Point table
Dec. time
Auxiliary function
SET button
UP or DOWN
button
