Mitsubishi Electric CITY MULTI PUMY-P200YKM3, Руководство по обслуживанию

Страница: 119 / 127

OCH791 _119
• Press the TEMP button to set a mode.
• Direct the wireless remote controller toward the receiver of the indoor unit and press the
h
button.
→ The sensor-operation indicator will blink and beeps will be emitted to indicate the setting number.
Setting number: 1 = 1 beep (0.4 seconds each)
2 = 2 beeps (0.4 seconds each, repeated twice)
3 = 2 beeps (0.4 seconds each, repeated 3 times)
Notes:
• If a setting number that cannot be recognized by the unit is entered, the setting will turn back to the original setting.
• If the signal was not received by the sensor, no beep or a ˝double beep˝ will be emitted. Reenter the setting number.
5. Repeat steps 3 and 4 to make other funtion setting on the same unit.
6. Repeat steps 2 to 4 to change the unit and make function settings on it.
7. Complete the function settings
• Press button.
Note:
• Do not use the wireless remote controller for 30 seconds after completing the function setting.
ON/OFF
TEMP
FAN
VANE
MODE
CHECK LOUVER
TEST RUN
AUTO STOP
AUTO START
h
min
CHECK
RESET SET CLOCK
ON/OFF button
Check button
Temperature setting buttons
Hour button
Minute button
13-5-3. PAR-SL101A-E
Operating instructions
1. Go to the function select mode.
• Press the button for 5 seconds. (Start this operation from the status of remote controller display turned off.)
CHECK
appears on the display and ˝00˝ blinks.
• Press the button to enter ˝50˝.
• Direct the wireless remote controller toward the receiver of the indoor unit and press the button.
2. Set the unit number.
• Press the button to set unit number A.
• Direct the wireless remote controller toward the receiver of the indoor unit and press the button.
A
3. Select a mode
• Press the button to set the mode number B.
• Direct the wireless remote controller toward the receiver of the indoor unit and press the button.
Setting number: 1=1 beep (1 second)
2=2 beeps (1 second each)
3=3 beeps (1 second each)