Configuration and CFG-300 LCD Service Tool
42
Command Menu-->Panel Config
Opt Zone Label
Use the keys in described below for entering message. These keys are alternate functions of bypass switches and
are physically located in the same position as described below.
Command Menu-->Panel Config
Default Configuration
Note:
Refer to
How to Use the Keypad to Program the FA-300
on page 34 for detailed instructions on
making menu selections.
Command Menu/
Panel Config
/Opt. Zone
Lab
1.Indicating zone messages
4.
[NAC-1 ]->Default
[NAC-2 ]->Default
[NAC-3 ]->Default
[NAC-4 ]->Default
BYPASS SWITCH TRANSLATION
KEY SEQ 1 2 3 4 KEY SEQ 1 2 3 4
--------------------------------------
Zone-1 0 Q Z Zone-2 1
Zone-3 2 A B C Zone-4 3 D E F
Zone-5 4 G H I Zone-6 5 J K L
NAC-1 6 M N O NAC-2 7 P R S
NAC-4 8 T U V NAC-3 9 W X Y
Aux Disconnect Back Space Lamp Test Forward
Press “UP” and “DOWN” to select
between Y/N. if “ENTER” is pressed the
default configuration is restored.
Use this function to load the
default configuration in the
panel.
Warning:
By loading default
configuration all the previously
programmed configuration is
lost permanently.
Indicating Zone
1 NAC-1
2 NAC-2
3 NAC-3
4 NAC-4
NAC-1 Label
SIGNAL-1
NAC-4 Label
SIGNAL-4
L o a d t h e d e f a u l t
s e t t i n g s ? Y
D e f a u l t s e t t i n g s
h a v e b e e n l o a d e d